Filter
Top Products
Appendix B - LCM Run Screen Overview
62 334135B
Appendix B - LCM Run Screen Overview
Splash Screen
This screen is activated during a boot up condition. The
splash screen will only be present approximately for five
seconds.
Disable Mode Screen
When the system is in this mode, all outputs are dis-
abled. This mode is activated in the bootup situation, or
if the user presses the System Shut-Down Key. To exit
this mode, the user simply needs to press the Power On
icon softkey.
Shot Mode Screen
This mode is the dispensing mode where the user can
define a shot amount by defining the percentage of
stroke for the dispense operation. When dispensing in
this mode, the machine will produce the same amount of
material for each dispense. To dispense out of this
mode, the user needs to momentarily press the dis-
pense key, or press an optional footswitch.
Operator Mode Screen
This mode is the dispensing mode where the dispense
amount is dictated by the duration the user is requesting
the dispense. To dispense in this mode, the user can
either press and hold the dispense key, or press and
hold an optional footswitch. If the user releases the
footswitch or dispense key, the dispense operation will
terminate, and the pump will return to the retract
position unconditionally.
Mode Selection Programming Screen
This programming mode is entered by pressing the
mode select designation soft key option, from any of the
three possible run mode screens. When activated, the
user can select between Shot, Manual and Maintenance
modes. The highlighted graphics in the top left portion of
the display will indicate the current selection.