Filter
Top Products
G0459 12" Drum Sander
-13-
Installing Crank
Handle
Components and Hardware Needed: Qty
Crank Handle ....................................................
1
The crank handle is installed on the front right
lift screw shaft, and is held in place with two set
screws already threaded into the handle.
To mount the handwheel:
1. Place the crank handle over the shaft shown
in Figure
6 and, using a 3mm hex wrench,
secure the handle with the two set screws
.
Figure 6. Crank handle installation.
Dust Collection
Components and Hardware Needed: Qty
Dust Hoses 2
1
⁄2" (not included) ...... Length Varies
Hose Clamps (not included) .......................
Varies
Dust Collection System (not included) ...............
1
This drum sander requires a minimum of
400
CFM AT THE DUST PORT
.
Note:
Do not confuse this CFM recommendation
with the rating of the dust collector. To determine
the CFM at the dust port, you must take into
account many variables, including the rating of
the dust collector, the length of hose between the
dust collector and the machine, the amount of
branches or wyes, and the amount of other open
lines throughout the system.
A fine layer of dust will be present on your stock
as it comes out of the sander. This is normal.
To connect the dust port to a dust collector:
1. Remove the four Phillips head screws at the
dust port hole.
2. Place the 2
1
⁄2" dust port over the top cover
mounting holes and secure with the Phillips
head screws removed in Step 1 as shown in
Figure 7.
3. Attach a 2
1
⁄2" dust collection hose to the dust
port and secure it with a hose clamp.
Figure 7. Dust port installation.
4. Connect the sander to the power source.