Filter
Top Products
G9729 Combination Lathe/Mill
-53-
Always disconnect
power to the machine
before performing ser-
v
ice adjustments. Failure
to do this may result in
serious personal injury.
This section is designed to help the operator with
adjustments that were made at the factory and
that might also need to be made during the life of
the machine.
This section is provided for your convenience—
it is not a substitute for the Grizzly Service
Department. If any adjustments arise that are not
described in this manual, then feel free to call the
Grizzly Service Department at (570) 546-9663.
Similarly, if you are unsure of how to perform
any procedure in this section, the Grizzly Service
Department will be happy to guide you through
the procedures or help in any other way.
About Service
SECTION 8: SERVICE
!
Gibs
There are three gib adjustments for the Model
G9729— the cross-slide gib, the compound slide
gib and the apron gib.
Cross-slide Gib: The gib on the cross-slide is
adjusted by tightening or loosening the 2 wing
bolts located on the right hand side of the slide
(see Figure 74). These will also serve as table
locks.
Figure 74. Gib adjustment wing bolts.
Continued on next page