Filter
Top Products
Model T10687 (Mfg. Since 10/12)
-15-
Dust Collection
Recommended CFM at Dust Port: 100 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
This machine creates substantial amounts
of dust during operation. Breathing air-
borne dust on a regular basis can result in
permanent respiratory illness. Reduce your
risk by wearing a respirator and capturing
the dust with a dust collection system.
Figure 8. Dust port location.
To connect a dust collection hose:
1.
Fit the 1
1
⁄2" dust hose over the dust port (see
Figure 8), and secure in place with a hose
clamp.
2.
Tug the hose to make sure it does not come
off. Note: A tight fit is necessary for proper
performance.
Dust
Port
Figure 7. T25331 48-Tooth Blade.
T25331—48-Tooth Blade for T10687 Saw
T25094—Accessories Pack for T24872 Rail
A.
Rail Track Connector .................................. 1
B.
Stabilizer ..................................................... 1
C.
Adjustable Stop .......................................... 1
D.
F-Clamps .................................................... 2
Figure 6. T25094 Accessories Pack.
A
B
C
D