Filter
Top Products
Model T10687 (Mfg. Since 10/12)
-23-
The stabilizer (see Figure 25) clips the saw onto
the rail track to help prevent the saw from acci-
dentally derailing. The stabilizer is attached to the
base plate.
Using Adjustable
Stop
Using the Stabilizer
The adjustable stop (see Figure 24) attaches to
the rail track and is positioned in front of the saw
body. The adjustable stop fits on the outer rail of
the rail track and provides a stable stopping point
along the rail track, which is especially useful
when making plunge cuts.
Figure 24. Adjustable stop on rail track.
Adjustable Stop
Figure 26. Stabilizer on rail track.
Stabilizer
Figure 25. Stabilizer clipped over rail track.
Base Plate
Rail Track
Stabilizer
To position the stabilizer against the rail track,
loosen the thumb screw and adjust the outer lip of
the stabilizer around the outside of the rail track,
as shown in Figure 26. Retighten the thumb
screw once the stabilizer lip is in place.
When not in use, remove the stabilizer from the
saw base plate. The stabilizer rests slightly lower
than the saw base plate and could affect the angle
of the blade to the workpiece when not attached
to the rail track.