Filter
Top Products
-26-
Model T10687 (Mfg. Since 10/12)
Tools Needed
• #2 Phillips Screwdriver
• Small Flat-End Screwdriver
• Needle-Nose Pliers
To replace the carbon brushes:
1.
DISCONNECT SAW FROM POWER!
2. Place saw on its side, with the motor cover
facing up.
3. Using a Phillips screwdriver, loosen the four
motor cover screws.
Motor Cover
Adjusting Zero-Stop
Set Screw
The zero-stop set screw (see Figure 27) keeps
the saw resting at exactly 90°. It can be adjusted
using a 2.5mm hex wrench.
Figure 27. Location of zero-stop set screw.
Zero-Stop Set Screw
To adjust the zero-stop set screw:
1. Place the saw on a flat, level surface.
2. Align the outside edge of the saw with a car-
penter's square or a straight, level block.
3. Using the 2.5mm hex wrench, adjust the
zero-stop set screw until the outside edge of
the saw is flush against your square or block.
Replacing Brushes
This saw uses two carbon brushes to transmit
electrical current inside the motor. Replace the
carbon brushes when the motor no longer reaches
full power or if it fails to start and run consistently.