Filter
Top Products
Page 13For technical questions, please call 1-800-444-3353.SKU 32650
Slide the Washer (13) and the Keyed 4.
Washer (48) onto the Shaper Spindle,
and thread the Nut onto the end of the
Shaper Spindle.
Figure 13
Cutter
(sold separately)
Spindle Wrench (54)
Double
Ended
Wrench
(55)
Shaper Spindle (47)
Nut (49)
5. Use the Spindle Wrench (54) to hold the
Shaper Spindle in place while tightening
the Nut clockwise with the small end of
the Double Ended Wrench (55).
WARNING! The Keyed washer must be
directly under the Nut (49) or else
serious injury may occur. Be careful to
tighten the Nut (49) and the Height Knob
(16) securely.
Installing Router Bits
Remove the Shaper Spindle (47) if it is 1.
installed.
Figure 14
Router Collet Nut (51)
Router Bit
(sold separately)
Table Top (7)
Router Bit
Collet (50)
Main Spindle (43)
2. Insert the Router Bit Collet (50) into the
Main Spindle (43).
Place the Router Collet Nut (51) over the 3.
Router Bit Collet and thread it clockwise
so that it is loosely in place on the Main
Spindle.
Insert the Table Insert (8).4.
Figure 15
Router Collet Nut (51)
Router Bit
(sold separately)
Table Insert
Table Top (7)
5. Insert the router bit (sold separately) into
the Main Spindle.
Firmly tighten the bit in place by turning 6.
the Router Collet Nut (51) clockwise
with the Double Ended Wrench (55)
REV 10e