Filter
Top Products
Page 16 For technical questions, please call 1-800-444-3353. SKU 32650
Chip Discharge
Chute (9)
Adapter (52)
Figure 11
1. To add Adapter, slide it into the
Discharge Chute.
Adapter (52)
Fence Assembly (2)
Figure 20
Chip
Discharge
Chute (9)
2. Use the four Bolts (10) to secure the
Chute onto the Fence Assembly (2).
Attache your vacuum to the end of the
Chute or Adapter.
Radius Pin
The Radius Pin (6) is used as a guide
for freeform work, in place of the Fence
Assembly (2).
Figure 21
Radius Pin (6)
Other possible location
for Radius Pin
Table Top (7)
1. To set up the Shaper/Router for freeform
projects, remove the Fence Assembly (2)
and thread the Radius Pin (6) clockwise
into the hole shown above.
Figure 22
Radius Pin (6)
Ring Guard (11)
Table Top (7)
2. Install the Ring Guard.
Miter Gauge
Figure 23
Miter Knob (1d)
Miter Scale (1a)
Slots to secure
workpiece
Miter Indicator (1b)
Miter Bar (1c)
The Miter Gauge Assembly (1) is an
adjustable guide that slides along the
channel in the Table Top (7) to guide the
workpiece into the blade at a specic
angle. The unit is adjustable from 0° to
±60°. The workpiece can be secured to
the Miter Gauge with pan head screws
through the two slots in the face of the
gauge.
REV 10e