Filter
Top Products
TP-6880 10/14 15Section 1 Descriptions and Service Views
DC2 Controller Features
D Four-button keypad: OFF, AUTO, RUN, and
EXERCISE pushbuttons
D LED indicators for OFF, AUTO, and RUN modes
D LCD display:
d Two lines x 16 characters per line
d Backlit display with adjustable contrast for
excellent visibility
D Scrolling system status display
d Generator set status
d Voltage and frequency
d Engine temperature
d Oil pressure
d Battery voltage
d Engine runtime hours
d Maintenance reminders
d OnCuer Plus status (connected/disconnected)
D Date and time displays
D Smart engine cooldown senses engine temperature
D Digital isochronous governor to maintain
steady-state speed at all loads
D Digital voltage regulation: ±0.5% RMS no-load to
full-load
D Automatic start with programmed cranking cycle
D Exercise modes
d Unloaded weekly exercise with complete system
diagnostics
d Unloaded full-speed exercise
d Loaded full-speed exercise (Model RXT ATS
required)
D Front-access mini USB connector for SiteTecht
connection or the Kohler USB utility
D Integral Ethernet connectorfor Kohlerr OnCuerPlus
D Built-in 2 .5 amp battery charger
D Remote two-wire start/stop capability for optional
connection of Model RDT or RSB transfer switches
D Diagnostic messages
d Displays diagnostic messages for the engine,
generator set, model RXT transfer switch, and
optional programmable interface module (PIM)
and load control module (LCM) or load shed kit
d Over 70 diagnostic messages can be displayed
D A laptop computer and Kohler r SiteTech software
can be used to change system settings
D A laptop computer and Kohlerr SiteTech software or
Kohler USB Utility software can be used to update
controller firmware
See the generator set Installation manual for more
information.
1.7 OnCue Plus Generator
Management System
The OnCuer Plus Generator Management System
comes included with your generator and allows
monitoring and control of your generator set from a
personal computer, smart phone, or tablet. OnCuer
Plus can be configured to send email or text message
notifications in the event of a generator set fault. See
TP-6928, OnCuer Plus Software Operation Manual,for
software instructions.