Filter
Top Products
TP-6880 10/14 39Section 3 RDC2 Controller Operation
3.12 Generator Set Information
Menu
The generator set model number and serial numbers
are displayed. No changes are allowed from this menu.
Model andserial numbersare factoryset andshould not
require changes in the field, except in the event that the
controller is being replaced. A personal computer
runningKohler SiteTechsoftwareisrequiredto enterthe
generator set model number and serial numbers on a
replacement controller. Contact an authorized Kohler
distributor/dealer for service.
tp6804
Genset M/N:
20RESV
Genset S/N:
Controller S/N:
<---- Return
Genset ---->
Information
########
########
Figure 3-13 Generator Set Information Menu
3.13 Genset Run Time Menu
The data shown in Figure 3-14 are displayed. No
changes are allowed from this menu.
Eng Runtime displays the total number of hours that the
generator set engine has run. The runtime is not
resettable.
The Next Maintenance menu shows the number of
hours of generator set operation until maintenance is
required. The estimated date for the next scheduled
maintenance is also displayed. The maintenance
reminder intervals are based on the engine
manufacturer’s recommendation for changing the oil.
Refer to Section 5, Scheduled Maintenance, for
maintenance instructions.
After changing the oil and performing other
recommended maintenance, go to the Overview menu
to reset the maintenance timer. See Section 5.2.5 for
instructions to reset the maintenance timer.
tp6810
Eng Runtime:
12345.6 h
Eng Starts:
123456
<---- Return
Genset ---->
Run Time
Next Maintenance:
150 h or Mar2012
Note: Sample data shown.
Figure 3-14 Generator Set Run Time Menu