Filter
Top Products
C-1
ACCESSORIES
C-1
OPTIONAL FIELD INSTALLED
ACCESSORIES
K802R POWER PLUG KIT - Provides a plug for each
receptacle.
K857 28 ft. (8.5 m) or K857-1 100 ft. (30.4 m)
REMOTE CONTROL - Portable control provides same
dial range as the output control on the welder from a
location up to the specified length from the welder. Has
convenient plug for easy connection to the welder. The
Commander 400 is equipped with a 6 pin connector
for connecting the remote control and a toggle switch
for selecting “LOCAL” output control or “REMOTE” out-
put control.
K704 ACCESSORY SET - Includes 35 feet (10 m) of
electrode cable and 30 feet (9 m) of work cable, head-
shield, work clamp and electrode holder. Cable is
rated at 500 amps, 60% duty cycle.
K953-1 TWO WHEEL TRAILER - For road, in-plant
and yard towing. Road towing with optional fender &
light kit. (For highway use, consult applicable federal,
state and local laws regarding possible additional
requirements)
K953-1 Trailer
K958-1 Ball Hitch
K958-2 Lunette Eye Hitch
K959-1 Fender & Light Kit
K965-1 Cable Storage Rack
K825-1 ETHER START KIT - Provides maximum cold
weather starting assistance for frequent starting below
10 F (-12.2
o
C). Required Ether tank is not provided
with kit.
K899-1 SPARK ARRESTOR KIT - Easily mounts to
standard muffler.
K949-1 OIL DRAIN KIT - Includes ball valve, hose and
clamp.
RECOMMENDED EQUIPMENT
STICK
K704 Accessory Kit which includes:
• Electrode holder and cable.
• Ground clamp and cable.
• Headshield.
K857 Remote Control Kit is optional for remote cur-
rent control.
TIG
Magnum TIG Torch
Magnum Parts Kit and Argon gas
K930-1 TIG Module (not required for scratch start
DC TIG welding)
K936-3 Control Cable
K870 Foot Amptrol
Also available:
K812 Hand Amptrol
K814 Arc Start Switch
K937-22 Control Cable Extension
K937-45 Control Cable Extension
K844-1 Water Valve
HIGH FREQUENCY GENERATORS FOR
TIG APPLICATIONS
The K799 Hi-Freq Unit and the K930-1 TIG Module are
suitable for use with the Commander 400. The
Commander is equipped with the required R.F. bypass
circuitry for the connection of high frequency generat-
ing equipment. The high frequency bypass network
supplied with the K799 Hi-Freq Unit does NOT need
to be installed into the Commander.
The Commander and any high frequency generating
equipment must be properly grounded. See the K799
Hi-Freq Unit and the K930-1 TIG Module operating
manuals for complete instructions on installation, oper-
ation, and maintenance.
COMMANDER 400