Filter
Top Products
F-10
DIAGRAMS
F-10
COMMANDER 400
CONNECTION DIAGRAM:
Disconnect NEGATIVE (-) BATTERY LEAD
Do not touch electrically live parts.
14 PIN
AMPHENOL
TO WORK
ELECTRODE
before servicing.
Do not operate with panels open.
TO WORK
CAUTION :
THE ENGINE WELDER OPERATING MANUAL.
APPLICATIONS. SEE OPERATING MANUAL.
PLACE LOCAL / REMOTE SWITCH IN "REMOTE" POSITION.
Keep guards in place.
COMMANDER 400 STICK & WIRE / LN-8 CONNECTION DIAGRAM
Keep away from moving parts.
WARNING
Only qualified personnel should install,use
or service this equipment.
TO LN-8 INPUT
K595 CONTROL CABLE
S22917
CABLE PLUG
N.B. USE VOLTMETER SWITCH TO SELECT DESIRED ELECTRODE POLARITY. POSITION THE RANGE SWITCH TO "WIRE WELDING CV".
ELECTRODE CABLE
TO WIRE FEED UNIT
N.A. WELDING CABLES MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE AND FUTURE
AN INCREASE IN THE THE AC AUXILIARY VOLTAGE. IF THIS VOLTAGE GOES OVER 140 VOLTS, WIRE FEEDER CONTROL CIRCUITS MAY BE
ANY INCREASE OF THE HIGH IDLE ENGINE RPM BY CHANGING THE GOVERNOR SETTING OR OVERRIDING THE THROTTLE LINKAGE WILL CAUSE
DAMAGED. THE ENGINE GOVERNOR SETTING IS PRE-SET AT THE FACTORY - DO NOT ADJUST ABOVE RPM SPECIFICATIONS LISTED IN
12-13-96