Filter
Top Products
F-8
DIAGRAMS
F-8
COMMANDER 400
CONNECTION DIAGRAM:
GND
75
76
77
GREEN
K291 OR K404
75
INPUT CABLE
76
N.E.
77
TO WORK
K775 OPTIONAL
REMOTE CONTROL
DAMAGED. THE ENGINE GOVERNOR SETTING IS PRE-SET AT THE FACTORY - DO NOT ADJUST ABOVE RPM SPECIFICATIONS LISTED IN
14 PIN
81
42
41
31
31
32
32
2
2
4
4
21
21
GND
82
N.D.
ELECTRODE CABLE
TO WIRE FEED UNIT
N.A. WELDING CABLE MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE AND FUTURE
APPILICATIONS. SEE OPERATING MANUAL.
LN-7
WIRE
FEEDER
COMMANDER 400 STICK & WIRE / K867 / K775 / LN-7 CONNECTION DIAGRAM
SPARE
13-13-96
S22915
}
}
AMPHENOL
TO WORK
N.D. INSULATE EACH UNUSED LEAD INDIVIDUALLY.
N.E. SPLICE LEADS AND INSULATE.
ELECTRODE
K867 UNIVERSAL
ADAPTER PLUG
CAUTION :
ANY INCREASE OF THE HIGH IDLE ENGINE RPM BY CHANGING THE GOVERNOR SETTING OR OVERRIDING THE THROTTLE LINKAGE WILL CAUSE
AN INCREASE IN THE THE AC AUXILIARY VOLTAGE. IF THIS VOLTAGE GOES OVER 140 VOLTS, WIRE FEEDER CONTROL CIRCUITS MAY BE
THE ENGINE WELDER OPERATING MANUAL.
PLACE WIRE FEEDER SWITCH TO "WIRE FEEDER WITH CONTROL CABLE POSITION.
N.B. USE VOLTMETER SWITCH TO SELECT DESIRED ELECTRODE POLARITY. POSITION THE "RANGE" SWITCH TO "WIRE WELDING CV".
N.C. IF OPTIONAL REMOTE OUTPUT CONTROL IS USED, PLACE LOCAL / REMOTE SWITCH IN "REMOTE" POSITION.
Keep guards in place.
or service this equipment.
Keep away from moving parts.
Only qualified personnel should install,use
Do not touch electrically live parts.
before servicing.
Disconnect NEGATIVE (-) BATTERY LEAD
Do not operate with panels open.
WARNING