Filter
Top Products
P 8/ 20
Repair
[3] DISASSEMBLY/ASSEMBLY
[3]-3. Tool holder section
DISASSEMBLING
ASSEMBLING
(1) Disassemble Chuck section as illustrated in Figs. 3 and 4.
(2) Disassemble Tool holder as illustrated in Fig. 15.
M8x30 Hex
socket head
bolt
Separate Barrel section from Crank housing complete.
And pull off Barrel section from Barrel cover.
Removing Ring spring 35, disassemble Tool holder
by striking it with plastic hammer.
M8x30 Hex
socket head
bolt
Barrel cover
Ring spring 35
M6x30 H.
s head bolt
with GM
Fig. 15
Tool holder
O ring 35.5
Barrel complete has to be assembled so that the notch is located on the opposite side of M6 bolt hole. (Fig. 16)
Rubber ring 39
Flat washer 39
Fig. 16
Hole for M6 Bolt bored on
Crank housing complete
Crank housing complete
Barrel complete
Notch of Barrel
complete