Filter
Top Products
DFG-SERIES SURFACE GRINDERS OPERATION AND PARTS MANUAL REV #4 (05/28/09) PAGE 17
ASSEMBLY INSTRUCTIONS/OPERATIONS
FIGURE 3
6) Assemble the two each, hose clamps P/N
14821-012 over the PN 290018-093 vacuum
hose. Install the vacuum hose over the vacuum
hose attach fittings. Determine that the
configuration minimizes potential kinks or
depressions, which can reduce the airflow.
Secure the hose clamps tight with the
screwdriver.
7) The DFG-1000 Safety and Dust Shield
Assembly Kit can be removed by reversing the
above procedure and reinstalling the original
bumper P/N 29018-016
8) Return the SURFACE GRINDER to its normal
operating position.
9) If the SURFACE GRINDER is powered by a
gasoline engine, reconnect the engine spark
plug wire. If powered by an electric motor and
the machine is to be used immediately,
reconnect the extension cord or SURFACE
GRINDER to the power source. Determine that
the ON/OFF switch located on the operator
handle is in the OFF position.
DANGER
UNEXPECTED MACHINE START UP CAN
RESULT IN PROPERTY DAMAGE AND/OR
PERSONAL INJURY.
Before Starting the Engine
FILLING THE ENGINE CRANKCASE WITH OIL.
Applications: DFG/G SURFACE GRINDER.
Tools Required:
1 each, small, clean funnel.
The DFG/G Series SURFACE GRINDER is
equipped with a Honda GX340 gasoline engine. This
engine is normally not pre-serviced at the factory
and will require the addition of oil in the crankcase
before being placed in service. Consult the material
supplied by the engine manufacturer for the engine
that has been ordered with your SURFACE
GRINDER. Carefully review this material to become
familiar with specific operating characteristics,
recommendations and service requirements.
1) Determine the location(s) of both the oil filler and
oil drain plug(s).
2) Wipe oil, dust and accumulated dirt from the
filler plug area.
3)
Using the funnel, fill the engine crankcase with a
high grade motor oil. Consult the material
supplied by the engine ma nufacturer for proper
amount, weight and service classification.
4) Replace the oil filler plug and tighten. Wipe off
any excess oil spilled on the engine crankcase
and SURFACE GRINDER.
5) Do not operate the engine unless proper oil level
is maintained as per the material supplied by the
engine manufacturer.
FILLING THE DFG/G SERIES ENGINE FUEL
TANK.
Tools Required:
1 each, small, clean funnel.
CAUTION
Never mix oil with gasoline. Four cycle engines
are not designed to be operated with oil mixed
with the gasoline.
1) Determine the location of the fuel tank filler cap.
2) Carefully clean the filler cap and surrounding
area to insure that no dirt or debris falls into the
fuel tank. Remove the filler cap.