Filter
Top Products
DECALS.
DFG SERIES SURFACE GRINDERS OPERATION AND PARTS MANUAL REV #3 (07/13/06) PAGE 76
DECALS.
KEEP
GUARDS IN
PLACE
SP8-5050
WARNING
WARNING
BEFORE HOISTING THIS MACHINE
CONSULT THE APPLICABLE OPERATOR
MANUAL. IMPROPER HOISTING
PROCEDURES CAN RESULT IN
PROPERTY DAMAGEAND/OR PERSONAL
INJURY.
KEEP CLEAR
OF ROTATING
PARTS
WARNING
SP8-5030
CS8-5030
WARNING
1) BEFORE OPERATINGTHIS MACHINE, THOROUGHLY READ AND
COMPREHEND THE CONTENTS OFTHE APPLICABLE OPERATOR'S MANUAL.
2) BEFORE STARTINGTHE POWER SOURCE, RAISETHE BLADE TO FULLY
TO CLEARTHE WORK SURFACE. VISUALLY INSPECTTHE BLADE/ARBOR
SHAFT.
3) THIS MACHINE IS DESIGNED TO BE PULLEDTOWARD THE OPERATOR
DURING NORMAL OPERATION.
IMPROPER STARTING/OPERATING PROCEDURES CAN RESULT IN PRORERTY
DAMAGE AND/OR PERSONAL INJURY.
SP8-5040
EYE AND EAR
PROTECTION
REQUIRED
WARNING
1
2
4
3
7
6
WARNING
SP8-5070
Improper extension cords will cause the moto to over heat and deploy the internal thermo
protection device. the device is intended to stop the motor before the heat can cause
permanent damage. It must be manually activated to restart the motor after a sufficient
time for cooling is allowed.
OPERATE THE MOTOR FROM THE PROPER POWER SOURCE
A voltage selector switch is provided on the electric motor. Retain the switch in position
with a long shank type lock. Determine the voltage and amperage capacity of the power
source before operating the motor. Do not operate the motor on an improperly selected
power source. Do not deploy the voltage selector switch while the motor is operating.
Improper voltage and amperage capacity can result in motor damage and/or personal
injury.
This machine can be operated from the following power sources:
115 VOLT, 20AMPERE, 60 HZ, AC ELECTRIC
OR
230 VOLT, 10AMPERE, 60 HZ,AC ELECTRIC
UTILIZE 8-3 AWG MINIMUM, COPPER STRANDED EXTENSION CORDS.
8
7
5
WARNING
PROPANE CONVERTED UNITS ONLY
STARTING INSTRUCTIONS
4. 1 SEC
5.
3.
CLOSE FUEL VALVE. INSPECT
ALL FUEL HOSES AND FITTINGS
FOR LEAKS AND DAMAGE
AFTER STOPPING ENGINE.
CONSULT OPERATOR'S MANUAL
FOR SPECIFIC INFORMATION.
OPEN FUEL VALVE
DO NOT USE CHOKE
SG24-5060