Filter
Top Products
22
3. After powering up the components, connect the MATE to the HUB.
PATH
M
AIN--------------------- SETUP------------------ SETUP/MATE/PAGE1 SETUP/MATE/PAGE2 SETUP/MATE/COMM
12.15:30p choose device: mate code rev: 402 choose category: choose category:
choose category:
SUM STATUS SETUP ADV FX MATE CLOCK CNT GLOW PG2 PG1 SUMRY COMM PG3 BACK REPOLL PC DEBUG
The FXs are now ready to be programmed according to the stacking options described in the next
section.
a) Plug the MATE into the 1st MATE Port on the HUB.
b) The MATE will power up and should recognize any component connected to the HUB.
c) The MATE can then program the FXs.
d) The fth MATE screen (Port Assignment) should display all the FXs and any OutBack Charge Controllers
in the system.
MATE Screens
PATH
G’day Mate (C) 2007 Version Searching Port Assignment
OutBack Code a.aa for Devices 1> FX 2> FX 3> CC 4> CC
Power 5> 6> 7> 8>
Systems Serial #xxxxxxxx HUB Found 9> 10> 2M>
Screen EE b.bb
4. To verify the MATE recognizes each HUB connected FX and OutBack Charge Controller, disconnect
and then either (a) reconnect the MATE to view its boot-up and repoll sequence or (b) follow this path
to manually repoll: