Filter
Top Products
38
After setting up your OutBack Parallel Stacking and establishing the Master and Slave order, shut o all
the AC input and output breakers and check your system via the following MATE screens:
From the ADV/FX/STACK power save level slave adjust only screen, press the <DOWN> soft key, the <TOP> soft
key, and then the <DOWN> soft key.
Verify this is the power save level
master adjust only screen. Press
the <PORT> soft key until P01
appears on the screen. Turn on all
of your FX AC Output breakers.
The Master FX’s “INVERTER” LED
should be solid and all the Slaves
“INVERTER” LED’s should be
blinking.
Press the <INC> soft key to
adjust the power save level master
adjust only from 0 to 1 and watch
the 1st Slave’s “INVERTER” LED go
solid. When the “INVERTER” LED is
on solid, this means that the in-
verter is on. When the “INVERTER”
LED on the Slave is blinking, this
means the FX is asleep.
Press the <INC> soft key once to
adjust the power save level master
adjust only to 2 and watch the
2nd Slave’s “INVERTER” LED turn
on
ADV/FX/STACK---------P04
stack OB Slave L1
phase
DOWN INC DEC PORT
ADV/FX/STACK---------------
stacking setup
completed
TOP ADV MAIN
ADV/FX/STACK---------P04
power save level 3
slave adjust only
DOWN INC DEC PORT
ADV/FX/STACK--------P01
power save level 2
master adjust only
DOWN INC DEC PORT
ADV/FX/STACK---------P01
power save level 1
master adjust only
DOWN INC DEC PORT
ADV/FX/STACK----------P04
power save level 0
master adjust only
DOWN INC DEC PORT
ADV/FX/STACK--------P01
power save level 0
master adjust only
DOWN INC DEC PORT
ADV/FX/STACK---------P01
power save level 3
master adjust only
DOWN INC DEC PORT
Press the <INC> soft key once to
adjust the power save level master
adjust only to 3 and watch the 3rd
Slave’s “INVERTER” LED turn on. If
the system has more than three
Slaves, keep increasing the value in
the power save level master adjust
only screen and verify that each
Slave’s “INVERTER” LED comes on as
expected. This check veri es all FXs
are stacked correctly.
Adjust the power save level master
adjust only to 0 by pressing the
<DEC> soft key.