Filter
Top Products
9
Po werware 9350 Series 685 and 1085 Auxiliary Battery Cabinets
Installation Manual 164201408 Rev. P00 053002
DANGER: CABINET MA Y FALL!
DONOTLOOSENTHEHARDWAREATTACHINGTHESIDEORFRONT
SUPPORTS TO THE CABINET BASE, OR THE FRONT AND SIDE SUPPORTS
TO EACH OTHER, AT THIS TIME.
THE CABINET MUST BE LOWERED BY THE JACKING BOLTS BEFORE THE
SUPPORTS CAN BE REMOVED.
6. Carefully and evenly lower the cabinet by turning each jacking bolt consecutively
two full turns (maxim um)
until the supports contact the floor, and the cabinet is
no longer supported by the jacking bolts.
7. After the battery cabinet is resting on the floor, remove the jacking bolts and
discard or recycle them in a responsible manner.
8. Remove the hardware, labeled “2” in Figure 5, holding the front, rear and side
supports to the cabinet base. Discard or recycle the hardware and support
brackets in a responsible manner.
9. Replace the doors that were removed in Step 1. The battery cabinet is now
readytoberolledtoitsfinallocation.
10. Repeat Steps 1 through 9 for each cabinet you are preparin g to install.
Creating an Installation Plan
Before beginning to install y our battery cabinet, you should be sure that you
understand the portions of this manual that apply to your system. Use the
procedures and illustrations in the following sections to create a logical plan for
installing the battery cabinet you purchased. Refer to Chapter 3, “Connecting to
Powerware 9350 30 ---160” to help plan your installation.