Filter
Top Products
Operator Manual, Supercharger 60 R3.0
Page 21 of 62
4.12 DS1A - RESET:
4.12.1. Indicates that the unit is in standby.
4.13 DS1B - CYC END:
4.13.1. Flashing (with pulsating beeper) cycle end. Indicates that the unit has completed
its cycle.
4.14 DS2A - DUAL:
4.14.1. Indicates that the DUAL rate mode (MAIN and TOPPING) is selected.
4.15 DS2B - MAIN:
4.15.1. Indicates that the unit is in MAIN charge.
4.16 DS3A - SINGLE:
4.16.1. Indicates that the SINGLE rate mode (Topping) is selected.
4.17 DS3B - TOP:
4.17.1. Indicates that the unit is in TOPPING charge.
4.18 DS4A - AUTO:
4.18.1. Indicates that the AUTO (analysis) mode is selected.
4.19 DS4B - DISCH:
4.19.1. Indicates that the unit is in AUTO discharge.
4.20 DS5A - FULL:
4.20.1. Indicates that the FULL (deep cycle) mode is selected.
4.21 DS5B - DISCH:
4.21.1. Indicates that the unit is in FULL discharge.
4.22 DS6A - CAP FAIL:
4.22.1. Indicates that the battery has failed to meet capacity.
4.23 DS6B - OPEN LIM:
4.23.1. Indicates that either the charge or discharge limiters are open.
4.24 DS7A - OVR TEMP:
Indicates Overtemp fault.
4.24.1. Continuous (no beeper): Indicates that the TEMP-PLATE is not connected (or
open).
4.24.2. Flashing: Indicates battery temperature in excess of 45
o
C).