Filter
Top Products
14
ASSEMBLY
UNPACKING
This product requires assembly.
Carefully lift saw from the carton and place saw on the
side with the wheels.
NOTE: This tool is heavy. To avoid back injury, keep your
knees bent and lift with your legs, not your back, and get
help when needed.
Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
Do not discard the packing material until you have
carefully inspected and satisfactorily operated the tool.
The saw is factory set for accurate cutting. After
assembling it, check for accuracy. If shipping has
influenced the settings, refer to specific procedures
explained in this manual.
If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
WARNING:
If any parts are damaged or missing, do not
operate this tool until the parts are replaced.
Failure to heed this warning could result in seri-
ous personal injury.
WARNING:
Do not attempt to modify this tool or create ac-
cessories not recommended for use with this
tool. Any such alteration or modification is misuse
and could result in a hazardous condition leading
to possible serious personal injury.
WARNING:
Do not connect to power supply until assembly
is complete. Failure to comply could result in ac-
cidental starting and possible serious personal
injury.
WARNING:
Do not lift the saw without help. Hold it close to
your body. Keep your knees bent and lift with
your legs, not your back. Ignoring these precau-
tions can result in back injury.
WARNING:
Never stand directly in line with the blade or
allow hands to come closer than 3 in. to the
blade. Do not reach over or across the blade.
Failure to heed this warning can result in serious
personal injury.
WARNING:
To avoid serious personal injury, always make
sure the table saw is securely mounted to a
workbench or an approved leg stand. NEVER
operate the saw on the floor.
MOUNTING HOLES
The table saw must be mounted to a firm supporting surface
such as a workbench or leg stand. Four bolt holes have been
provided in the saw’s base for this purpose. Each of the
four mounting holes should be bolted securely using 3/8 in.
carriage bolts, washers, lock washers, and wing nuts. Bolts
should be of sufficient length to accommodate the saw base,
washers, lock washers, wing nuts, and the thickness of the
workbench. Tighten all four bolts securely.
Carefully check the workbench after mounting to make sure
that no movement can occur during use. If any tipping, slid-
ing, or walking is noted, secure the workbench to the floor
before operating.