Filter
Top Products
16
ASSEMBLY
TO SECURE/LEVEL THE SAW
See Figure 10.
With the leg stand open and the table saw resting on a flat,
level surface, the saw should not move or rock from side
to side.
If the saw rocks from side to side, the leveling feet need
adjusting until the leg stand is balanced.
Loosen both the top and bottom wing nuts.
Lift the saw slightly so that you may turn the leveling foot
until the leg stand no longer rocks.
• Turning clockwise will lower the foot
• Turning counterclockwise will raise the foot
TO STORE THE TABLE SAW ACCESSORIES
See Figure 11.
The table saw has two convenient storage areas specifically
designed for the saw’s accessories. These accessories
must be securely stored prior to closing the leg stand and
moving the saw.
Always store the blade guard when making non-through cuts
and/or transporting the saw. Slide blade guard in storage
area. Snap bottom edge of clear basket between latches
on base.
To store the rip fence, place the top edge in first and twist
downward to snap into place. To remove, pull up on fence
and rotate bottom away from saw.
Pull latch forward and slide miter gauge in storage area. To
remove miter gauge, pull latch forward and lift straight up.
Secure blade wrenches and saw blade using extra washers
provided to separate blades and prevent tooth damage.
Fig. 11
MITER
GAUGE
BLADE GUARD
ASSEMBLY
RIP FENCE
LEVELING
FOOT
WING NUT
Fig. 10
WING
NUT