Filter
Top Products
30
OPERATION
MAKING A BEVEL CROSS CUT
See Figures 39 - 40.
It is recommended that you place the piece to be saved on
the left side of the blade and that you make a test cut on
scrap wood.
WARNING:
Make sure the blade guard assembly is installed
and working properly to avoid serious personal
injury.
Remove the rip fence by lifting the locking lever.
Unlock the bevel locking lever and move height/bevel
adjusting handwheel until bevel indicator is at desired
angle.
Push the bevel locking lever toward the table to relock.
Set the blade to the correct depth for the workpiece.
Set miter gauge to 0° and tighten the lock knob.
Place a support (the same height as saw table) behind
the saw for the cut work.
Make sure the wood is clear of the blade before turning
on the saw.
Let the saw blade build up to full speed before moving
the miter gauge and the workpiece into the blade.
Hold the workpiece firmly with both hands and feed the
workpiece into the blade.
NOTE: The hand closest to the blade should be placed
on the miter gauge lock knob and the hand farthest from
the blade should be placed on the workpiece.
When the cut is made, turn the saw off. Wait for the blade
to come to a complete stop before removing any part of
the workpiece.
VIEWED FROM THE FRONT, BELOW THE TABLE SAW
BEVEL
LOCKING LEVER
TO
LOOSEN
HEIGHT/BEVEL
ADJUSTING
HANDWHEEL
BEVEL CROSS CUT
BLADE
ANGLED
MITER GAUGE
STRAIGHT
Fig. 39
Fig. 40
UNLOCK
BEVEL
LOCKING
LEVER
BEVEL
INDICATOR
LOCK KNOB
TO
TIGHTEN