Filter
Top Products
ASSEMBLY
-16-
Figure 21. Belt tracking lock knob, dust port
cover, and quick release lever.
Figure 22. Sanding belt directional installa-
tion.
Figure 20. Platen and dust hood tilt.
Dust Hood
When connected to a dust collection system, the
dust hood directs suction to remove harmful
wood and abrasive dust from your work area.
For additional information on the correct dust
collection system, additions, or modifications;
contact your Woodstock International dealer for
your copy of the Dust Collection Basics
hand-
book and available accessories.
To connect dust hood, do these steps:
1. Locate your dust edge sander where it will be
used
2. Connect your dust collection suction tube to
the dust port, so when you tilt the platen
from the vertical to the horizontal position,
the suction tube will not bind, leak, or dis-
connect the dust-collector ducting ground.
See Figure 20.
Sanding Belt
Your Model W1688 Edge Sander is shipped with a
general purpose sanding belt great for most
woodworking needs. With proper care, machine
operation, and dressing the belt with the use of
a PRO-STIK
®
belt cleaner available through your
Woodstock International dealer, your edge
sander belt will enjoy extended service life.
To install the sanding belt, do these steps:
1. Loosen the belt tracking lock knob. See
Figure 21.
2. Unlatch and open the dust port cover. See
Figure 21.
DO NOT operate this
machine without the cor-
rect dust collection sys-
tem. Failure to use a dust
collection system can
result in short and long-
term respiratory illness.
Dust Hood Cover
Quick Release Lever
in Unlocked Position
Belt
Tracking
Lock
Knob
Arrows Must Point this
Direction
Dust Port