Filter
Top Products
OPERATION
-28-
Figure 48. DO NOT sand wood with sharp cor-
ners at the leading-edge of the sanding opera-
tion. The belt can grab and throw the wood.
Figure 49. ALWAYS sand wood with sharp
corners at the trailing-edge of the sanding
operation.
5. Set the miter gauge to the needed angle.
6. Set the workpiece on the table and against
the miter gauge. See Figure 49.
7. Carefully sand the wood with sharp
corners at the trailing-edge of the sanding
operation. See Figure 49.
DO NOT sand a workpiece with the sharp cor-
ners at the leading-edge of the sanding opera-
tion. The belt can grab and propel the work-
piece causing injury. See Figure 48.