Filter
Top Products
SAFETY
-5-
12. Do not force tool. The machine will do a safer and better job at the rate for which it was designed.
13. Use correct tool. Do not force machine or attachment to do a job for which it was not designed.
14. Wear proper apparel. Do not wear loose clothing, neck ties, gloves, jewelry, keep long hair tied up,
etc.
15. Remove adjusting keys and wrenches. Before turning the machine on, make it a habit to check that
all adjusting keys and wrenches have been removed.
16.
16.Use proper extension cord. Examine the
extension cord to ensure it is in good condi-
tion. Use
TABLE 1 to determine the correct
length and gauge of extension cord needed
for your particular needs. The amp rating of
the motor can be found on its nameplate. If
the motor is dual voltage, be sure to use the
amp rating for the voltage you will be using.
If you use an extension cord with an under-
sized gauge or one that is too long, excessive
heat will be generated within the circuit
increasing the chance of a fire or damage to
the circuit. Always use an extension cord
that uses a ground pin and connected ground
wire. Immediately replace a damaged exten-
sion cord.
17. Keep proper footing and balance at all times.
18. Do not leave machine unattended. Wait until it comes to a complete stop before leaving the area.
19. Perform machine maintenance and care. Follow lubrication and accessory attachment instructions
in the manual.
20. Keep machine away from open flame.
Operating machines near pilot lights and/or
open flames creates a high risk if dust is dis-
persed in the area. Dust particles and an
ignition source may cause an explosion. Do
not operate the machine in high-risk areas,
including but not limited to, those men-
tioned above.
21. If at any time you are experiencing diffi-
culties performing the intended operation,
stop using the machine! Then contact our
service department or ask a qualified expert
how the operation should be performed.
22. Habits—good and bad—are hard to break.
Develop good habits in your shop and safety
will become second-nature to you.
Extension Cord Requirements
TABLE 1
Length and Gauge
Amp Rating 25ft 50ft 100ft
0-6 #18 #16 #16
7-10 #18 #16 #14
11-12 #16 #16 #14
13-16 #14 #12 #12
17-20 #12 #12 #10
21-30 #10 #10 No
Always wear safety glasses or goggles when
operating equipment. Operating this equip-
ment creates the potential for flying debris
that can cause eye injury. Everyday glasses
or reading glasses only have impact resistant
lenses, they are not safety glasses. Be cer-
tain the safety glasses you wear meet the
appropriate standards of the American
National Standards Institute (ANSI).