Filter
Top Products
OPERATION
-25-
Starting the Sander
ALWAYS take a few moments to listen and
observe for unusual noise and vibration after
starting the edge sander.
DO NOT start this sander
until you have complet-
ed all assembly, adjust-
ments, safety require-
ments, and you have
read and understand this
entire manual.
INSTRUCTION MANUAL
MODEL W1688
EDGE SANDER
Phone: 1-360-734-3482 • On-Line Technical Support: shopfox.biz
COPYRIGHT © SEPTEMBER, 2002 BY WOODSTOCK INTERNATIONAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT
THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.
Printed in Taiwan
Always wear a dust mask
and safety glasses when
operating this machine.
Sawdust may cause aller-
gic reactions or respiratory
problems.
Make sure loose clothing
and long hair is secured
and kept away from
moving parts.
OPERATIONS
To start the edge sander, do these steps:
1. Pull the ON/OFF switch up. See Figure 40.
2. Position your finger over the ON/OFF switch
so you are ready to shut the sander OFF if
there is a problem. See Figure 41.
3. Listen for any unusual noises. The sander
must run smoothly with little or no vibration.
4. If unusual noise or vibration exists, shut the
sander off immediately. DO NOT restart the
sander until you correct the problem.
5. Remove the safety lockout key and unplug
the sander, troubleshoot the source of the
noise or vibration, and correct the problem.
DO NOT make any adjustments to the sander
while it is plugged in. See Figure 42.
Figure 40. ON/OFF switch in the ON position.
Figure 41. Ready for emergency shut down.
Figure 42. Safety lockout key removed.