Filter
Top Products
-14-
Df[\cN(/).=fiDXZ_`e\jD]^%J`eZ\*&()
J<KLG
+% Position the cutter guard over the threaded holes in
the table.
Efk\1K_\^lXi[ZXeY\gfj`k`fe\[fm\i\`k_\igX`i
f]_fc\j#[\g\e[`e^lgfek_\i\hl`i\d\ekjf]k_\
fg\iXk`fe%
,% Insert the tie-down assemblies with
1
⁄2" flat washers
through the slots in the guard, and thread them into
the table to secure the guard in place, as shown in
=`^li\/.
=`^li\/% Securing the guard to the table.
@ejkXcc`e^=\eZ\
(% Slide a handwheel onto a fence adjuster shaft as you
align the set screw in the handwheel with the shaft
indent, as shown in =`^li\0.
=`^li\0% Attaching handwheel to fence
adjuster.
Indent
Groove
=`^li\('% Installing fence adjuster.
)% On each side of the guard, insert a fence adjuster
through the bracket, as shown in =`^li\(', and
align the groove on the shaft (see =`^li\0) with the
middle bolt.
*% Tighten the middle bolt into the shaft groove just
enough to keep the fence adjuster in place as it
turns.