Filter
Top Products
-37-
Df[\cN(/).=fiDXZ_`e\jD]^%J`eZ\*&()
D8@EK<E8E:<
ClYi`ZXk`fe
Since all bearings are sealed and permanently lubricated,
simply leave them alone until they need to be replaced.
Do not lubricate them. However, the spindle slide and
leadscrew do need lubrication with NLGI#2 grease.
KfclYi`ZXk\k_\jg`e[c\jc`[\Xe[c\X[jZi\n#[fk_\j\
jk\gj1
(% DISCONNECT SHAPER FROM POWER!
)% Use the spindle height handwheel to lower the
spindle all the way, then access the elevation
assembly through the rear of the cabinet (see
=`^li\+0).
*% Use mineral spirits, shop rags, and a stiff brush
to clean away grease and built-up grime from
the surfaces of both slides and the threads of the
leadscrew, then apply a thin coat of NLGI#2 grease
or equivalent to these surfaces.
+% Fully raise and lower the spindle to distribute the
grease.
=`^li\+0% Spindle slide and leadscrew.
Slide
Leadscrew