Filter
Top Products
-19-
Df[\cN(/).=fiDXZ_`e\jD]^%J`eZ\*&()
FG<I8K@FEJ
FG<I8K@FEJ
>\e\iXc
This machine will perform many types of operations
that are beyond the scope of this manual. Many of these
operations can be dangerous or deadly if performed
incorrectly.
The instructions in this section are written with the
understanding that the operator has the necessary
knowledge and skills to operate this machine. @]XkXep
k`d\pflXi\\og\i`\eZ`e^[`]]`Zlck`\jg\i]fid`e^Xep
fg\iXk`fe#jkfglj`e^k_\dXZ_`e\
If you are an inexperienced operator, we strongly
recommend that you read books or trade articles, or
seek training from an experienced shaper operator before
performing any unfamiliar operations. 8Yfm\Xcc#pfli
jX]\kpj_flc[Zfd\]`ijk
I<8;Xe[le[\ijkXe[k_`j\ek`i\`ejkilZ$
k`fedXelXcY\]fi\lj`e^ k_`jdXZ_`e\%
J\i`flj g\ijfeXc `ealip dXp fZZli `]
jX]\kpXe[fg\iXk`feXc`e]fidXk`fe`jefk
le[\ijkff[ Xe[ ]fccfn\[% ;F EFK i`jb
pflijX]\kpYpefki\X[`e^
:fekifcGXe\c
Refer to =`^li\)' and read the following descriptions
below to become familiar with the control panel of your
shaper.
8% Gfn\iFE9lkkfe%Enables power to the machine.
9% Gfn\iJfliZ\CXdg%Illuminates when power is
enabled to the machine.
:% I<M@e[`ZXkfiCXdg%Illuminates when the spindle
is set to rotate in reverse. This alerts the operator
to verify that the cutter is setup correctly before
proceeding with the cut.
;% Jg`e[c\Jn`kZ_%Starts, stops, and reverses spindle
rotation.
<% <d\i^\eZpJKFG9lkkfe%Disables power to the
motor. Twist clockwise until it pops out to reset it.
=% Gfn\iF==9lkkfe% Disables power to the machine.
=`^li\)'% Control panel.
A
E
B C
D
F
8 CN8P J Z_ \Z b k _ \ [ `i \ Z k` f e f ] k _ \ Zl kk \i
ifkXk`feY\]fi\Y\^`ee`e^fg\iXk`feXe[
8CN8PJ]\\[k_\jkfZb`ekfk_\Zlkk\i
8>8@EJK k_\ Zlkk\i ifkXk`fe% =\\[`e^
jkfZbN@K?k_\ifkXk`fef]k_\Zlkk\i
Zflc[ glcc k_\ nfibg`\Z\ ]ifd pfli
_Xe[j Xe[ [iXn pfli _Xe[j `ekf k_\
jg`ee`e^Zlkk\i#i\jlck`e^`ecXZ\iXk`fe
fiXdglkXk`fe`eali`\j%