Filter
Top Products
-27-
Df[\cN(/).=fiDXZ_`e\jD]^%J`eZ\*&()
FG<I8K@FEJ
Each hold-down is independently adjustable, and, when
properly positioned, they firmly hold the workpiece
flat on the table and against the fence, as shown in
=`^li\*+.
KfXjj\dYc\k_\_fc[$[fnej#[fk_\j\jk\gj1
(% DISCONNECT SHAPER FROM POWER!
)% Slide a hold-down into each of the cast iron hold-
down brackets with the large holes, and secure them
with the lock handles.
*% Insert the bracket bars into the fence brackets and
hold-down bracket.
+% Position the above assemblies according to the
workpiece size, then use the lock handles to secure
them in place.
,% Insert the
5
⁄16"–18 x 3/8" knob bolts with the 2
1
⁄2"
shafts into two hold-down brackets with the small
holes and loosely thread the T-nuts onto the knob
bolts.
-% Slide the assemblies from Jk\g, into the table miter
slot, position them according to the workpiece size,
then tighten the knob bolts to secure their position.
=`^li\*+% Example of workpiece held in
place by hold-downs.
=`^li\*,% Hold-downs assembled and
installed.
?fc[$;fnej
@]k_\nfibg`\Z\j_flc[i`j\lgn_\e
`k`jX^X`ejkk_\Zlkk\i#b`ZbYXZbZflc[
fZZli%Kfi\[lZ\k_\Z_XeZ\f]b`ZbYXZb
Xe[ j\i`flj g\ijfeXc `ealip# XcnXpj
gifg\icpj\Zli\k_\nfibg`\Z\n`k_k_\
_fc[$[fne[\m`Z\j[li`e^fg\iXk`fe%
8cnXpj n\Xi jX]\kp ^cXjj\j fi X ]XZ\ j_`\c[ n_\e
fg\iXk`e^k_`jdXZ_`e\kfXmf`[\p\fi]XZ\`eali`\j
]ifd]cp`e^[\Yi`j% Nff[[ljkdXp ZXlj\j_fikXe[
cfe^$k\id i\jg`iXkfip `cce\jj% Kf Xmf`[ k_`j _XqXi[#
XcnXpjn\XiXi\jg`iXkfi[li`e^fg\iXk`fe%