Filter
Top Products
-18-
Df[\cN(/).=fiDXZ_`e\jD]^%J`eZ\*&()
J<KLG
K\ j kI l e
K
N
@
J
K
Kn`jk9lkkfe:cfZbn`j\
KfI\j\kJn`kZ_%%%
=`^li\(0% Resetting the emergency stop
switch.
Once the assembly is complete, test run your machine
to make sure it runs properly and is ready for regular
operation.
The test run consists of verifying the following: 1) The
motor powers up and runs correctly, and 2) the safety
feature on the emergency STOP button works correctly.
If, during the test run, you cannot easily locate the source
of an unusual noise or vibration, stop using the machine
immediately, then review KiflYc\j_ffk`e^ on GX^\+*.
If you still cannot remedy a problem, contact our Tech
Support at (360) 734-3482 for assistance.
Kfk\jkilek_\dXZ_`e\#[fk_\j\jk\gj1
(% Make sure you understand the safety instructions
at the beginning of the manual, and verify that the
machine is setup properly.
)% Ensure all tools and objects used during setup are
cleared away from the machine.
*% Connect the machine to the power source.
+% Push the ON button (see =`^li\(/) to enable power
to the motor—the power source lamp should light.
,% Push the emergency STOP switch, then twist it
clockwise so it pops out. When the switch pops out it
is reset and ready for operation (see =`^li\(0).
-% Turn the FWD/REV switch to the right to verify the
machine operates correctly.
— When operating correctly, the machine runs
smoothly with little or no vibration or rubbing
noises.
— Investigate and correct strange or unusual noises
or vibrations before operating the machine further.
Always disconnect the machine from power when
investigating or correcting potential problems.
.% Turn the FWD/REV switch to the OFF (middle)
position and press the emergency STOP switch to
turn the machine F==.
=`^li\(/% Control panel.
/% WITHOUT resetting the emergency
STOP switch, turn the FWD/REV switch
to the right in an attempt to start the
machine. The machine should EFK
start.
— If the machine ;F<J start (with the
emergency STOP button pushed in),
immediately disconnect power to
the machine. The emergency STOP
switch safety feature is not working
correctly. This safety feature must
work properly before proceeding
with regular operations. Call Tech
Support for help.