Filter
Top Products
8 INCRA Woodworking Tools & Precision Rules
3
Attach fence glides
Note: The fence glides included in
hardware pack B-08 are configured
for the Shopsmith model 520. To
convert the glide for the model 510,
see the bottom of this page.
Place one of the supplied ¾” x 3”
cardboard spacers under each end
of the fence as shown in Fig. 16 and
attach the two fence glides to the rear
of the fence using (4) ¼-20 x ½” socket
head cap screws, ¼” washers and ¼-20
square nuts. Capture the nuts in the
lower T-slot on the fence. See Fig. 17.
Slide the glide onto the fence and
position it so that the UHMW pad on the
underside sits on top of the Shopsmith
rail and the white nylon spacer is about
1
/
32
” away from the outside of the rail.
Visually level the glide and tighten
the fasteners. Finally tighten the (2)
fasteners that secure the fence to the
fence mounting bracket. Take care not
to raise or lower the fence mounting
bracket as you tighten the screws.
Remove and save the cardboard
spacers.
Figure 16
Figure 17
Figure 18
Converting the fence glides
for the model 510
Remove the fasteners and the large
diameter nylon spacers from each of
the two fence glides. Remove one
of the UHMW bearing strips from
each of the fence glides as shown.
Remove the UHMW from the left
side of one glide and the right side of
the other. See Fig. 18. Using ¼-20
x 1-½” Phillips head screws with
washers and ¼-20 lock nuts, attach
the 1” long nylon spacers to the glide
through the holes located near the
edge of the glide. Retain the large
diameter nylon spacers and fasteners
for future re-conversion should you
upgrade to the model 520 rails.
First: Place
cardboard spacers
under fence
Second: Attach
fence glide
Capture
nuts in
lower
T-slot
Fence glide
Nylon spacer approximately
1/32” away from rail
UHMW pad sits
on top of rail
¼-20 x ½” socket fasteners
with washers and square nuts
Attach conversion
hardware here
Fence glide
1” long nylon spacer
¼-20 x 1½”
Phillips head
screw with washer
Remove UHMW
pads from opposite
sides of glides