Filter
Top Products
62.
• Have blade extend approximately 1/8" above top of work piece.
Additional blade exposure would increase the hazard potential.
• Do not stand directly in front of the blade in case of a KICKBACK.
Stand to either side of the blade.
• Keep your hands clear of the blade and out of the path of the
blade.
•
If the blade stalls or stops while cutting, TURN SWITCH OFF
before attempting to free the blade.
• Do not reach over or behind the blade to pull the work piece
through the cut … to support long or heavy workpieces … to
remove small cut-off pieces of material or FOR ANY OTHER
REASON.
• Do not pick up small pieces of cut-off material from the table.
REMOVE them by pushing them OFF the table with a long stick.
Otherwise they could be thrown back at you by the rear of the
blade.
• Do not remove small pieces of cut-off material that may become
TRAPPED inside the blade guard while the saw is RUNNING.
THIS COULD ENDANGER YOUR HANDS or cause a KICKBACK.
Turn the saw OFF. After the blade has stopped turning, lift the
guard and remove the piece.
• If workpiece is warped, place the CONCAVE side DOWN. This
will prevent it from rocking while it is being ripped.
Ripping
RIPPING is known as cutting a piece of wood with the grain, or
lengthwise. This is done using the rip fence. Position the fence to
the desired WIDTH OF RIP and lock in place. Before starting to rip,
be sure:
A. Rip Fence is parallel to sawblade.
B. Spreader is properly aligned with sawblade.
C. Anti-kickback pawls are functioning properly.
When ripping LONG BOARDS or LARGE PANELS, always use a
work support. A simple one can be made by clamping a piece of
plywood to a sawhorse (Fig. 42).
BEVEL RIPPING
When bevel ripping material 6" or narrower, use fence on the right
side of the blade ONLY. This will provide more space between the
fence and the sawblade for use of a Push Stick. If the fence is
mounted to the left, the sawblade guard may interfere with proper
use of a Push Stick.
When “WIDTH OF RIP” is 6" and WIDER use your RIGHT hand to
feed the workpiece, use LEFT hand ONLY to guide the workpiece
… do not FEED the workpiece with the left hand (Fig. 43).
When “WIDTH OF RIP” is 2" to 6" wide USE THE PUSH STICK to
feed the work (Fig. 44).
FIG. 42
FIG. 43
FIG. 44
SM 2610008289 02-10:3310 Table Saw 2/2/10 8:39 AM Page 62