Filter
Top Products
9
Figure 9
1. Attach the Dremel
®
Rotary Hobby Tool to
the Tool Holder Assembly from the Dremel
#330 Router Attachment Kit as stated in
the Router Attachment Kit Owner’s
Manual. See Figure 9.
2. Secure the hobby tool assembly to the
router table using the Bracket Mounting
Screws from the #330 Router Attachment
Kit.
3. The solid insert that comes with this
router table can be drilled out off center to
give you better small workpiece support.
Switch Box
Introduction
A conveniently located Switch Box allows the
operator to:
• turn the router ON and OFF from the front
of the table
• simultaneously operate other devices
such as a light or a vacuum
DREMEL
®
O
N
OFF
WOLF113-24
It also features a resettable, internal circuit
breaker (NN, Figure 12) that protects your
equipment against overloads.
Electrical Hookup
Proper grounding diverts potentially danger-
ous electricity away from the operator. The
switch box is intended for use with a three-
prong, grounded outlet. (See Figure 10.) The
switch box’s electrical cord features an equip-
ment-grounding connector and a grounding
plug. Insert the plug into an accommodating
outlet that conforms to all local electrical
codes and the National Electric Code (NEC).
DO NOT modify the plug. If it
does not fit correctly, a qualified
electrician must install a compatible outlet.
Avoid the risk of electrical
shock. NEVER connect the
equipment grounding connector (green wire)
to a “hot” electrical terminal. When repairing
or replacing the electric plug or cord, DO
NOT connect the grounding connector to a
“hot” electrical terminal.
Figure 10
Consult a qualified electrician if you do not
understand the grounding procedures, or if
you are not sure whether the switch box is
correctly grounded.
Damaged and/or worn cords must be
repaired or replaced immediately.
Extension cords must be three-wire, 14
gauge or larger, with three-prong “male”
plugs, and three hole “female” receptacles
fabricated to accept the tool’s plug.
WOLF108-13
WARNING
WARNING