If a message for calibration appears, remove the film, then place the Film Adapter Unit over the
first frame of the Film Guide and click OK.
When the calibration is completed, follow the on-screen instructions to load the film into the
Film Guide, then click OK.
Note
To preview another frame, place the Film Adapter Unit over the frame you want to scan, then
click Preview.
5.
Set Output Settings.
Output Settings
Note
When the data size exceeds 1.8 GB, change the settings to reduce the size.
6.
Adjust the cropping frame, correct image and adjust colors as required.
djusting Cropping Frames
Image Settings
Color Adjustment Buttons
7.
Click Scan.
Scanning starts.
Note
To scan another frame, place the Film Adapter Unit over the frame you want to scan, then repeat
Steps 4 to 7.
ScanGear's response after scanning can be specified in Status of ScanGear dialog after scanning
on the Scan tab of the Preferences dialog box.
Scan Tab
Related Topic
dvanced Mode Tab
Page top
Page 176 of 308 pagesScanning Film in Advanced Mode
