On-screen Manual
>
Scanning Guide
>
Let's Try Scanning
> Scanning Film
Scanning Film
This machine supports 35 mm positive and negative film strips (standard state of developed film, with
six frames in each strip). You can scan one frame at a time.
Note
To scan at 4800 dpi or higher, scan from the Advanced Mode tab of ScanGear (scanner driver).
Scanning Film in Advanced Mode
35 mm Film Strip
1.
Start MP Navigator EX and open the Navigation Mode screen.
Starting MP Navigator EX
2.
Point to Scan/Import and click Film.
3.
Place the film on the Platen.
Placing Film
4.
Click Specify... to set the document size and scanning resolution as required.
When setting is completed, click OK.
Scan Settings Dialog Box (Film)
Important
Film may not be scanned correctly when Film Type in the Scan Settings dialog box is set to
uto. In that case, select the type of film in Film Type and scan again.
Note
To scan black and white film, it is recommended that you select Black and White Negative Film
or Black and White Positive Film for Film Type in the Scan Settings dialog box.
Page 32 of 308 pagesScanning Film
