Transmitting Documents
WorkCentre Pro 555/575 5-5
Memory Send
With Memory Send mode, the document is first assigned a job
number for internal control of reserved communications. Up to 100
jobs can be reserved. The Job Number is used to identify a
communication reserved for transmission or polling-reception, should
it become necessary to cancel that operation. Once the Job Number
is assigned, the document is scanned into memory, then the remote
number is dialed and the fax is sent.
During Memory Send mode, documents can be sent anytime the
Standby Mode is displayed. If the facsimile telephone line is busy or
the line of the remote facsimile is busy, the document data is stored in
memory and is sent when the lines becomes available.
To send a Document using the Memory Send mode:
1. Load the document face down in the Document Support.
2. Select the desired
Resolution
and
Contrast
.
3. Using one of the dialing methods, dial the fax number and press
Start
, if necessary. (See Chapter 4, “Dialing Methods”.)
The machine assigns a job number and scans the document into
memory.
After 2 seconds
…
The machine then dials the number, confirms the connection and
sends the fax.
Note: Memory Send mode is limited by the available memory
and is not possible when the Free Memory is at or near
0%. If there is not enough available memory, a Memory
Full message is displayed. Press Stop and wait until
memory is available or use Direct Send from the ADF.
Jan-31 02:23pm 100%
Auto answer
Doc. reading P001
Job number 022
Jan-31 02:23pm 85%
Auto answer
