Filter
Top Products
17
General Programming Aspects
Programming Recommendations
It is recommended to test a new setting that will be programmed on
the instrument by setting it up manually.
Enable the outputs so that the instruments error check system is on
and possible parameter conflicts are immediately displayed.
When you have found the correct setting, then use this to create the
program. In the program it is recommended to send the command for
enabling outputs (for example, :
OUTPut ON
) as the last command.
Selftest of the instrument can be invoked by the common command
*TST
If it is important to know whether the last command is completed,
then send the common command
*OPC?