Filter
Top Products
Error Codes GPIB Error Strings
262 Agilent 8163A/B, 8164A/B & 8166A/B Mainframes, Fifth Edition
Old -211
“Trigger ignored”
Description:
A trigger has been detected but ignored because of timing contraints. (For
Example: average time to large).
Old -212
“Ar m ignore d”
Description:
The user can set the automatic re-arming option for input and output trig-
ger events (see “Triggering - The TRIGger Subsystem” on page 171). When
this error occurs, the device ignores the setting because the current mod-
ule status does not allow the change of trigger settings.
Old -213
“Init ignored”
Description:
The INIT:IMM command (page 88) initiates a trigger and completes a full
measurement cycle. The continuous measurement must be DISABLED.
This error code is generated if the powermeter is still in cont. measure-
ment mode.
Old -220
"Parameter error (StatParmError)”
Description:
The user has passed a parameter that cannot be changed in this way. The
device cannot detect one of the following more specific errors:
Old -220
-220, "Parameter error (StatParmOutOfRange)"
Description:
The user has passed a parameter that exceeds the valid range for this pa-
rameter.
Old -220
"Parameter error (StatParmIllegalVal)"
Description:
The user has passed a parameter that does not match a value in a list of
possible values.
Table 18 Overview for Supported Strings
New/Old/Standard
Error
Number String