Filter
Top Products
The Conair CTS Saw is an on- or off-line sawing device capa-
ble of both on-demand and continuous cutting.
Conair CTS Saws can cut extrudable plastics and rubber both
on- and off-line. Other extrudable materials-foods, ceramics,
magnets, soaps, etc.-may also be cut depending on specific
application requirements.
CTS Saws are available with different cutting capacities (5, 7,
and 9 inches) to suit your specific needs. The standard saw
orientation is right-to-left, saws can also be made with a left-
to-right orientation (see Specifications in this section). (The
illustrations in this User Guide represent the standard right-to
left configuration.)
CTS saws are limited to a specific range of product sizes
based on each unit's cutting capacity.
Different materials, line speeds, temperatures and material
cross-sections can result in different cutting torques. If you are
changing any of these parameters, consult your Conair service
personnel to be sure your equipment can handle the changes.
WHAT IS THE
CTS SAW?
CTS Saw UGE058/0803
2-2 DESCRIPTION
TYPICAL
A
PPLICATIONS