Filter
Top Products
PRODUCT
QUALITY
PROBLEMS
C
ONTINUED
CTS Saw UGE058/0803
6-6 TROUBLESHOOTING
Symptom
◆ Incorrect cut
length
◆ Table motion
inconsistent
Possible cause
Encoder or input device
problem
Puller problem
Counter problem
Saw clamps not holding
Roller ways dirty
Rodless cylinder problem
Solenoid problem
Low air pressure
Solution
Check encode or input device
Check puller for drive consis-
tencies or any belt to product
slippage.
Check cut length counter
Check rubber saw clamps for
wear and replace as necessary
Clean roller ways
Check and clean rodless cylin-
der
Check table actuation solenoid
for proper operation
Check main system regulator
for incoming air pressure set-
tings