Filter
Top Products
Move the saw into position. Place the saw in posi-
tion downstream of the belt puller.
Determine the best distance from the belt puller to
the CTS Saw.
● For flexible products, the saw should be as close as
possible to the puller.
● For rigid products, leave enough space to allow
the product to flex during the cutting cycle. In some
cases, it may be necessary to allow 6-8 feet between
the puller and saw.
Align the saw with the extrusion line.
Measure the centerline height
of the extrudate as
it exits the extrusion die. Adjust all equipment on the
extrusion line (sizing tank, cooling tanks, belt puller, and
saw) to this height.
CTS Saw UGE058/0803
3-4 INSTALLATION
1
P
OSITIONING
THE
CTS SAW
CAUTION: Lifting
To avoid personal injury or damage to the saw,
lift the saw using a forklift or hoist with straps
that have been positioned at the saw's center of
gravity.
2
3
Saw
4
continued on the next page