Filter
Top Products
Appendix B-1 (16)
(MENU AREA)
Factory Softkey
This area is password protected for factory use only.
Please do not attempt to get around the password protection
as parameters beyond this point are used for calibration and
setup. These parameters should only be modified by trained
personal. Improper settings will reduce the performance
and possibly cause severe damage to your machine.
ERROR MESSAGE
If a cut has not completed within a safe amount of table
travel this message is displayed. The message will remain
until any key is pressed.
The saw will continue to attempt making cuts, but parts
will not be added to the total.
Corrective action would be to increase the speed of the
blade travel or reduce the amount of blade travel. Either
action will reduce the amount of table travel used while
making a cut.
Conair Servo
Traveling Saw
Operator Control
Instructions
SELECT MENU
Maint. Factory
COULDN’T COMPLETE
CUT IN SAFE DISTANCE