Filter
Top Products
Appendix B-1 (8)
Homing
A defined Home location is required for all servo-
positioning applications. After initial power up, Home must
be found. All moves are relative to the home location.
The Home cycle occurs once after initial power up in
response to the Start push button being pressed.
There are two kinds of home sequence, home seek and
home already.
Home Seek
If the saw table has been stopped away from the home
location and the power to the machine switched off, upon
reapplying power, the first motion will be a home seek.
Pressing the start push button begins the home seek cycle.
The table reverses towards the home sensor at reduced
speed. Once it finds the home sensor, the table will
decelerate to a stop approximately 0.0136 in. later. This
position is set to 0.000 at end of home.
Conair Servo
Traveling Saw
Operator Control
Instructions
Conair Servo
Traveling Saw
Operator Control
Instructions