Filter
Top Products
Appendix B-1 (5)
Main Screen
The Main Screen has three features. The top line displays
the Length Counter. The bottom line contains the two soft
key functions, Total and Length.
Length Counter
The Length Counter displays counts only when the
machine is started and soft key On/Off is on. If the machine
is stopped or soft key On/Off is off, this counter will be
forced to zero.
The length counter resides in the servo drive. The main
screen shows snapshots of the count value that is read over
the communications channel. A slight delay in updates will
be noticed.
If a negative symbol is shown to the left of the count value,
the encoder signal is reversed, i.e. rotating in the wrong
direction. The Saw will not function while the encoder is
going negative. It is possible to correct this by using the
Direction function on the Maintenance Area page found in
the Menu area. This will be shown later in the Menu
section of this manual.
On/Off Softkey
Under the count in the center of the bottom line of the
display is a soft key labeled On or Off. Pressing this key
while On is displayed will disable the counter. Likewise
pressing this key while Off is displayed enables the
counter. Pressing the stop button forces the counter off.
0000.000 in.
Total Off Length
Conair Servo
Traveling Saw
Operator Control
Instructions