Filter
Top Products
Appendix B-1 (14)
Return Softkey
Pressing the soft key located under the word Return on the
Table area screen. Selects the Table Return Speed screen.
The number shown is the current return speed in inches per
minute. A cursor will appear in the least significant digit.
The user has a choice of ways to adjust this number. The
acceptable range is 120.00-1800.00 ipm
Exit or Prev- if no change is required press Exit or Prev to
return to the Table area screen.
Raise will increase the preset by 10.00 imp. The key can be
pressed once for each 10.00 ipm increment required or held
down to scroll up. Releasing the key will freeze the preset
at the last value.
Lower will decrease the preset by 10.00 ipm. The key can
be pressed once for each 10.00 ipm decrement required or
held down to scroll down. Releasing the key will freeze the
preset at the last value.
Numeric keys
Key in the speed required and press enter. The decimal
place is fixed so remember this when entering the preset. If
you require 1200 inches per minute you must key in
120000 and then press enter. Keying only 1200 will set the
speed to 12.00 inches per minute and the out of range
warning will appear on the screen for 5 seconds.
Enter or Delete?
If the keyed in number is correct press the enter key for it
to be accepted and return to the Main screen. If it is wrong
press the delete key and the previous preset will reappear.
ENTER TABLE RETURN
SPEED 1200.00 ipm.
Conair Servo
Traveling Saw
Operator Control
Instructions