Filter
Top Products
INSTALLING THE YOKE ASSEMBLY
See Figures 13A - 13C.
The yoke rides in the carriage below the arm and
supports the motor, the blade guard, and the blade.
Install the yoke assembly from the front of the arm.
• Remove the cardage stop screw and Iockwasher
from below the front of the arm with a 1/4 in. hex
key. See Figure 13A.
ARMVIEWEDFROMBELOW
___.C LOCKWASHER
_R:InA::;::: SCREFWg.13A
• Remove the arm cap screws and arm cap from the
front ofthe arm with a phillips screwdriver. See
Figure 13B.
ARMLOCKKNOB
ARMCAPT. T
!
ARM
CAPSCREWS
Fig. 13B
• Remove and discard the two motor setscrews in
the bottom of the motor. They are for shipping
purposes only.
• Lock the arm with the arm lock knob, located on top
of the front of the arm, so the arm doesn't swing
while you are mounting the yoke assembly.
• Pick up the yoke assembly and carefully slip it onto
the carriage track below the arm. Keep it parallel
with the arm so bearings slide in smoothly. See
Figure 13C.
FORCLARITY,CARRIAGECOVERSAND CARRIAGELOCK
KNOBARENOTSHOWNIN ILLUSTRATION
ARMLOCK KNOB
BEARINGS(4)
CARRIAGE
YOKE
CARRIAGE ARM
LOCKKNOB
CARRIAGECOVER Fig. 13C
• Reinstall the carriage stop screw, the Iockwasher,
arm cap, and arm cap screws. Tighten all screws
securely.
,_, WARNING: Once the yoke assembly is on the
carriage track, reinstall the arm cap, the arm cap
screws, the carriage stop screw, and the
Iockwasher. Do not risk serious injury or damage
to the saw by failing to replace these parts.
• Tighten the carriage lock knob, on the carriage
cover on the left of the arm, to lock the yoke
assembly in place.
[RRFTSHRN"RADIALSAW315.220380 24