Filter
Top Products
NON-THROUGH CUTS
See Figure 49.
WARNING: Unplug the saw while removing or
replacing the blade guard. Tum on the saw with
the switch on the arm to confirm the blade is not
receiving power.
• Remove the blade and blade guard (see Assembly
section).
• Place a support the same height as the saw table
nearby for the cut work. Lower the blade with the
elevating handwheel.
• Make sure the wood is not touching the blade,
Insert the key and turn on the saw, Let the blade
build up to full speed before contacting the work-
piece.
_1= WARNING: Always use pushblocks when
making non-through rip cuts to avoid the risk of
serious injury, Never feed wood with your hands.
• When the work is completed, press the switch off
and remove the key.
NON-THROUGHCUT
Fig. 49
53 CRRFI"SNRIrRADIALSAW315.220380