Filter
Top Products
83
master ones no matter what the firmware version of slave controller is newer or older than
master. In normal status, the firmware versions in controller 1 and 2 are the same as
below figure.
Figure 4.6.4.1
4.6.5 Reset to factory default
“Reset to factory default” allows user to reset IP SAN storage to factory default setting.
Figure 4.6.5.1
Reset to default value, the password is: 123456, and IP address to default 192.168.0.32.
4.6.6 Import and export
“Import and export” allows user to save system configuration values: export, and apply
all configuration: import. For the volume configuration setting, the values are available in
export and not available in import which can avoid confliction / date-deleting between two
IP SAN storages which mean if one system already has valuable volumes in the disks and
user may forget and overwrite it. Use import could return to original configuration. If the
volume setting was also imported, user’s current volumes will be overwritten with different
configuration.
Figure 4.6.6.1